People use immersion rods because they are inexpensive. However, after prolonged use, the rods develop a white, crusty coating. Vinegar is considered effective in removing this coating.

With the arrival of winter, people prefer to take hot baths. Consequently, the use of geysers or immersion rods increases in homes. Because immersion rods are inexpensive, most people use them. However, after prolonged use, a white, crust-like layer of calcium and magnesium present in the water forms on the rod. This layer reduces the rod's efficiency.

This makes the water take longer to heat up and increases electricity consumption. If your rod has a similar coating, there's no need to panic. You can easily clean it with some common household items. So, today we'll tell you what kitchen items you can use to clean a white film that has formed on your immersion rod.

Cleaning with Vinegar:

Vinegar is considered very effective for removing the white film from an immersion rod. To do this, fill a bucket or deep vessel with enough water to completely submerge the rod. Add half to one cup of vinegar to the mixture and soak the rod in this water for 30 minutes to one hour. If the white film is thick, leave it overnight. Afterward, remove the rod, scrub it gently with a soft scrubber, and rinse with clean water. In just a few minutes, your rod will look as good as new.

Homemade Lemon and Salt Remedy:

The mixture of the acid in lemon and salt helps dissolve the white film on the immersion rod. To do this, first extract the juice of two to three lemons, add a teaspoon of salt, and make a thick paste. Apply this paste to the deposits on the rod, leave it for 15 to 20 minutes, then scrub with an old toothbrush, and then rinse with clean water. This will leave your immersion rod sparkling clean.

Baking soda is also an effective remedy.

If a white deposit has accumulated heavily on the immersion rod, baking soda is considered the best solution. To do this, mix two to three teaspoons of baking soda with a little water to form a paste. Apply this paste to the rod and leave it for 20 to 30 minutes. Then scrub gently with a sponge and rinse with clean water. This will leave your rod completely clean.

Keep these things in mind to increase the lifespan of your

immersion rod. If you want to ensure the longevity of your immersion rod, it's important to clean it once every 15 to 20 days. This will not only heat water faster but also reduce electricity consumption and double its lifespan.